- Tin Indian Performance Videos - 

Here is a collections of video from past races and dyno sessions that we thought you may enjoy.  We hope to add to this section on a regular basis.

This is Kevin Swaney making another record setting pass running 7.14 pass at 186.51 mph at Summit Motor Sports Park September 25, 2009.  

This is Kevin Swaney making another record setting pass running 7.26 pass at 184.45 mph at the 2009 Tripower Pontiac Nationals at Norwalk.

This is Jeff Kauffman in his digger and Kevin Swaney in the Tin Indian Performance digger going at it in the KRE Quick 16 qualifying at the Ames Performance Tripower Nationals held at Summit Motorsports Park August, 2009.

This is a 510 cid MR-1A ALL Aluminum Pontiac engine featuring a set of 80 cc KRE High Port heads with a custom ground Tin Indian Performance solid roller camshaft.  This engine made 760 horsepower and 704 ft lbs of torque.  This video is a 300 rpm per second pull on KRE's dyno.

This is the same 510 cid MR-1A ALL Aluminum Pontiac engine featuring a set of 80 cc KRE High Port heads with a custom ground Tin Indian Performance solid roller camshaft.  This engine made 760 horsepower and 704 ft lbs of torque.  This video is of the engine ideling at approximately 1000 rmp on KRE's dyno.

This is Jeff Kauffman in his digger and Kevin Swaney in the Tin Indian Performance digger going at it in KRE Quick 16 qualifying at the Ames Performance Tripower Nationals held at Summit Motorsport Park August, 2008.

This is Kevin Swaney making another 7.40 pass at the 2008 Tripower Pontiac Nationals at Norwalk.  Immediately following is Jeff Kauffman's record setting pass.  Jeff ran a 6.62 @ 209 mph!

This is footage of Kevin Swaney's 7.37 pass @ 179 mph at Summit Motorsports Park in 2007

Here is a clip of Mike Williams' 1966 GTO with a 505 cid MR-1 pontiac engine topped off with a set of 380 cfm KRE High Port heads.  The engine was built by Tin Indian Performance.  This pass was a 10.02 at Norwalk and the car has run a best of 9.17 @ 144 mph.

This is Mark Kauffman's  blown Pro-Mod Firebird. It's debut was at the 2004 Pontiac Nationals in Cordova, IL. With a 540 cid, 14-71 blown billet headed setup. 6.92 @ 202.30 

MR-1 cast iron block with KRE Series 1 Billet Aluminum Pontiac Heads

This is Jason Crawford's blown 511 MR-1A / KRE 80 cc High Port combo warming up for a dyno pull

This is Jason Crawford's blown 511 MR-1A combo making 801 hp and 796 ft lbs of torque on E85